Configuring And Viewing Pim-Dm For Ipv6 Multicast Routing - Dell PowerEdge M420 Configuration Manual

Configuring and Viewing PIM-DM for IPv6 Multicast Routing

Beginning in Privileged EXEC mode, use the following commands to
configure PIM-DM for IPv6 multicast routing on the switch and on VLAN
routing interfaces and to view PIM-DM information.
Command
configure
ipv6 pim dense
vlan-id
interface vlan
ipv6 pimdm
ipv6 pimdm hello-interval
seconds
exit
show ipv6 pim
show ipv6 pimdm interface vlan
vlan-id
show ipv6 pimdm neighbor
[interface vlan
1216
Managing IPv4 and IPv6 Multicast
vlan-id
| all]
Purpose
Enter global configuration mode.
Enable PIM-DM on the switch.
Enter Interface Configuration mode for the
specified VLAN.
Enable PIM-DM on the interface.
Specify the number of seconds (range: 0–65535)
to wait between sending PIM hello messages on
the interface.
Exit to Privileged EXEC mode.
View system-wide PIM-DM information.
View the PIM-DM information for the specified
interface.
View a summary or all the details of the multicast
table.