Inputs - B&K Reference 20 Plus Owner's Manual

Inputs

Usually these settings may be left set to the factory defaults. However, your processor allows 'fine tuning' how
your processor operates after the selection of an input source. Make sure you are in the SETUP MENUS and
your remote is in B&K mode.
MAIN MENU
1 Zone 1 Operation
2 Zone 2 Operation
3 Zone 1 Favorite Presets
4 Zone 2 Favorite Presets
5 System Setup
5 System Setup
6 Memory Backup/Restore
next item
MENU
6<67(0 6(783
From Remote
­ V
1
(PAUSE) or (STOP)
2 SEL or ENTER
Select input -
From Remote
X W
1
(REW) or (FF)
Set the favorite audio listening mode - Your processor provides for 4 audio listening modes Mono, Stereo,
Surround and DVD Audio (Optional) (See AUDIO MODES). You may set a default audio mode and speaker
selection (excluding selection 0 'Headphone', or selection 9 'LtRt') for each of your input sources. When a source
is selected from the remote control or front panel, the audio mode will automatically be set to use this favorite
mode and speaker selection. Note that DVDA mode can only be selected if that input is designated as the DVD
audio input below and the internal DVDA switch has been set (see DVD Audio using the Coax digital inputs under
MAKING THE CONNECTION).
SEL select
exit menu system
From Front Panel
(UP) or (DOWN)
(ENTER)
SETUP DVD
SETUP DVD
1 Favorite Mode
2 Favorite Speakers
3 Level
4 Name
5 Component Video
6 DVD Audio Input
next item
MENU setup system
6(783
From Front Panel
VOLUME KNOB
SETUP SYSTEM
1 Speakers
2 Displays
3 Inputs
3 Inputs
4 Presets
next item
MENU main menu
6(783 ,13876
Action
move to Inputs
activate SETUP INPUTS
INPUT
INPUT
Surround
7
0.0 dB
DVD
2
No
adjust
'9'
Action
select source
39
SEL select
13258 11/01