Advertisement
The TS setting allows the system to answer after two rings only if you have messages waiting. If the phone
rings 3 times, you have no messages waiting. Hang up before the system answers to avoid long distance
charges.
Turning Your System On
You can turn your system on by calling from any touch tone telephone.
1.
Dial your telephone number. The system will answer after 10 rings by beeping twice. (The system
will not play your announcement message.)
Press and release 0. The system is ready for the next remote command. Press and release * and leave a
2.
message or simply hang up.
When you hang up, the system remains on, ready to answer automatically and receive messages.
Turning Your System Off
1.
Dial your telephone number.
2.
When the system answers, enter your Remote Access code during or after the announcement.
3.
Press and release 8 8 to turn off the answering system. The system will not answer incoming calls until
you turn it on again.
When the Tape Is Full
When the tape is filled with messages, the system will answer after 10 rings by beeping 2 times. It does not
play your announcement and cannot record the caller's message.
You can reset the tape remotely to record over the old messages:
1.
To listen to messages, enter your Remote Access code within 15 seconds after the beeps.
2.
To make room for future messages, press and release 3 3 to reset the tape.
NOTE: Remember that when you reset the tape, new messages are recorded over the messages you
have just heard.
Advertisement
