Advertisement
ATT-1465QSG-d03(OK).qxd
Installation and setup
Connect the base and install batteries as shown below. After installation, place the
handset in the base and allow the battery to charge for 12 hours before use. You can
keep the battery charged by returning the handset to the base after each use.
NOTE: Use only the power cord
supplied with this product. If you need a
replacement, call 1 800 222–3111.
Be sure to use an electrical outlet not
controlled by a wall switch.
Press coin into slot on base
of handset to release latch,
then remove cover.
Plug in battery here.
To replace cover:
1 Insert tabs at top of
cover into slots on
base.
2 Align tab at bottom
of cover with slot in
base, then press to
click in place.
2/13/1950
7:21 PM
Plug long line cord
into telephone jack.
Page 3
NOTE: For wall mount-
ing, please see page 8 in your
User Manual.
Place handset in base to charge for 12
hours before first use.
Charging light will be illumi-
nated while battery is charging.
Rotate antenna to
fully upright position.
Plug power cord
transformer into
electrical outlet.
Advertisement
