Powering Off The Projector; Warning Indicator - Optoma HD700X User Manual

Installation
English
4

Powering Off the Projector

1. Press the "Power" button to turn off the projector lamp,
you will see a message displayed on the projector's screen.
2. Press the "Power" button again to confirm,
otherwise the message will disappear after 5 seconds.
When you press "Power" button second, the system will
show the timing countdown on the screen.
3. The cooling fans continue to operate for about 10 seconds
for cooling cycle. When the Power LED turn red, the pro-
jector has entered standby mode.
If you wish to turn the projector back on, you must wait until

the projector has completed the cooling cycle and has entered
standby mode. Once in standby mode, simply press "Power"
button to restart the projector.
4. Disconnect the power cord from the electrical outlet and
the projector.
5. Do not turn on the projector immediately following a
power off procedure.

Warning Indicator

When the "LAMP" indicator lights red, it indicates problem

with the lamp. Please contact your local reseller or service
center. See pages 48-49.
When the "TEMP" indicator lights red, it indicates the pro-

jector has overheated. The projector will automatically shut
itself down.
Under normal conditions, the projector can be switched on
again after it has cooled down. If the problem persists, you
should contact your local dealer or our service center.
See pages 48-49.
When the "POWER" indicator flashes red, it indicates the

fan has failed. Please contact your local dealer or our service
center. See pages 48-49.