Table of Contents
Advertisement
Controlling the projector through a LAN
environment
You can manage and control the projector from one or more remote computers when
they are properly connected to the same local area network.
Cable connection
If you are in a DHCP environment:
1.
Take a RJ45 cable and connect one end to the RJ45 LAN input jack of the projector
and the other end to the RJ45 port on your Ethernet or router.
2.
Do one of the following:
•
Press NETWORK SETTING on the remote control. The Network
Settings page is displayed.
•
Press MENU/EXIT and then press
Advanced menu is highlighted. Press
press ENTER. The Network Settings page is displayed.
3.
Highlight Wired LAN and press ENTER.
4.
Make sure the Status is Connect.
5.
Press
6.
Press
7.
Re-enter the Network Settings > Wired LAN page. The IP Address, Subnet
Mask, Default Gateway, and DNS settings will be displayed. Note down the IP
address displayed in the IP Address row.
If the IP Address still does not appear, contact your ITS administrator.
If you are in a non-DHCP environment:
1.
Repeat steps 1-4 above.
2.
Press
3.
Contact your ITS administrator for information on the IP Address, Subnet Mask,
Default Gateway, and DNS settings.
4.
Press
36
Operation
to highlight DHCP and press
to highlight Apply and press ENTER.
to highlight DHCP and press
to select the item you want to modify and press ENTER.
/
until the SYSTEM SETUP:
to highlight Network Settings and
/
to select On.
/
to select Off.
MX716
MX717
Advertisement
Table of Contents
