Configuring The Hco - HP d640 Installation And User Manual

Configuring the HCO

After you power up the HCO and check the connection, you're ready
to configure your printer for the HCO.
To configure the HCO:
Step 1 Power up the printer.
If the HCO is connected properly, you should see an HCO icon on the
printer's control panel.
Ready - - free
JUN 18 05:32.23
PCL
Online Offline
Offline
If the HCO icon doesn't appear, verify the following:
l
the HCO power switch is on.
l
the printer is connected to the HCO.
l
the interface cable is connected.
Step 2 On the printer control panel, press the Menu button and
Online
Online
Note For more information about using menus on the D640 printer, see the
Model D640 User Manual .
Step 3 Open the Printing menu and select outbin.
Online
Online
HCO icon
Custom Menu
select Printing.
Menu Printing
Configuration
PCL
Comms
Maintenance
Printing copies = 1
intray = tray1
paper
= auto
outbin = UPPER
duplex = OFF
binding = LONGEDGE
600dpi
LTR
LTR
LGR
LTR
Test PapSize
Chapter 1: Introduction 21