Lexmark CX310 Compatibility Manual page 90

Card stock & label guide
Hide thumbs Also See for CX310:
Table of Contents

Advertisement

Printer specifications
Media specifications
Labels
Width:
Length:
Weight:
Thickness:
Smoothness:
* 150–250 Sheffield is optimal. Using media higher than 300 Sheffield could result in printing degradation.
Card stock
Weight:
Note: Always use the rear exit when printing on card stock. To minimize curl, use the rear exit when printing on labels.
Card stock and label guidelines
When printing on labels:
Set the Paper Type to Labels from the printer driver, the Local Printer Setup Utility, or MarkVision.
Do not load labels together with paper or transparencies in the same paper source.
Do not use label sheets with a slick backing material.
Do not print within 1 mm (0.040 in.) of the die‑cut.
Use full label sheets. Partial sheets may cause labels to peel off during printing, resulting in a paper jam. Partial
sheets will also contaminate the printer and the cartridge with adhesive, and could void the printer and cartridge
warranties.
Use labels that can withstand temperatures of 205°C (401°F) without sealing, excessive curling, wrinkling, or
releasing hazardous emissions.
Use labels that can withstand pressure of 25 pounds per square inch (psi).
Do not print within 1 mm (0.040 in.) of the edge of the label, of the perforations, or between die-cuts of the label.
Do not use labels that have adhesive to the edge of the sheet. We recommend zone coating of the adhesive at least
1 mm (0.040 in.) from the edges. Adhesive material will contaminate the printer and could void the warranty.
If zone coating of the adhesive is not possible, a 3‑mm (0.125‑in.) strip should be removed on the leading and driver
edge, and a non‑oozing adhesive should be used.
Remove a 3‑mm (0.125‑in.) strip from the leading edge to prevent labels from peeling inside the printer.
Portrait orientation is preferred, especially when printing bar codes.
Do not use labels that have exposed adhesive.
For the multipurpose feeder, load labels with the recommended print side faceup and the top edge going in first.
For the tray, load labels with the recommended print side facedown.
When printing on card stock:
Set the Paper Type to Card Stock from the printer driver, the Local Printer Setup Utility, or MarkVision.
Do not use preprinted card stock manufactured with chemicals that may contaminate the printer. Preprinting
introduces semi‑liquid and volatile components into the printer.
Do not use card stock that is creased. It may cause paper jams.
We recommend the use of grain short card stock.
Load card stock with the recommended print side faceup and the top edge going in first.
76.2–216 mm (3.0–8.5 in.)
127–355.6 mm (5–14 in.)
2
Up to 199 g/m
(53 lb)
Up to 0.25 mm (0.01 in.)
100–400* Sheffield
2
Up to 163 g/m
Index Bristol (90 lb)
2
Up to 163 g/m
Tag (100 lb)
90

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents