Wake-Up Devices And Events - Intel BLKDX48BT2 Technical Product Specification

Intel Desktop Board DX48BT2 Technical Product Specification
1.13.1.2 ENERGY STAR*
In 2007, the US Department of Energy and the US Environmental Protection Agency
revised the ENERGY STAR* requirements. Intel has worked directly with these two
governmental agencies to define the new requirements. Currently this Intel Desktop
Board meets the new Category C requirements.
For information about
ENERGY STAR requirements and recommended configurations
1.13.1.3

Wake-up Devices and Events

Table 7 lists the devices or specific events that can wake the computer from specific
states.
Table 7. Wake-up Devices and Events
These devices/events can wake up the computer...
LAN
PME# signal
Power switch
RTC alarm
USB
WAKE#
Consumer IR
Note 1: For LAN and PME# signal, S5 is disabled by default in the BIOS Setup program. Setting this option
to Power On will enable a wake-up event from LAN in the S5 state.
Note 2: Wake from S4 and S5 is optional by the specification.
NOTE
The use of these wake-up events from an ACPI state requires an operating system
that provides full ACPI support. In addition, software, drivers, and peripherals must
fully support ACPI wake events.
34
Refer to
http://www.intel.com/go/energystar
...from this state
(Note 1)
S1, S3, S4, S5
(Note 1)
S1, S3, S4, S5
S1, S3, S4, S5
S1, S3, S4, S5
S1, S3
S1, S3, S4, S5
S1, S3 (S4 and S5) (Note 2)