S-Video Output; Legacy I/O Controller; Serial Port; Parallel Port - Intel BLKD945GCLF2D Technical Product Specification

Product specification
Table of Contents

Advertisement

Intel Desktop Board D945GCLF2 Technical Product Specification
1.8

S-Video Output

The D945GCLF2 desktop board supports S-Video output via a 7-pin S-Video connector
supporting both 4-pin S-Video and Composite signal. S-Video output is not available
on the D945GCLF2D desktop board.
1.9

Legacy I/O Controller

The I/O controller provides the following features:
One serial port
One parallel port with Extended Capabilities Port (ECP) and Enhanced Parallel Port
(EPP) support
Serial IRQ interface compatible with serialized IRQ support for PCI Conventional
bus systems
PS/2-style mouse and keyboard interfaces
Intelligent power management, including a programmable wake-up event interface
PCI Conventional bus power management support
The BIOS Setup program provides configuration options for the I/O controller.
1.9.1

Serial Port

The serial port A connector is located on the back panel. The serial port supports data
transfers at speeds up to 115.2 kbits/sec with BIOS support.
For information about
The location of the serial port A connector
1.9.2

Parallel Port

The 25-pin D-Sub parallel port connector is located on the back panel. Use the BIOS
Setup program to set the parallel port mode.
For information about
The location of the parallel port connector
20
Refer to
Figure 8, page 41
Refer to
Figure 8, page 41

Advertisement

Table of Contents
loading

This manual is also suitable for:

D945gclf2

Table of Contents