Maytag MDB5651AWB - Jetclean II Series Full Console Dishwasher Use & Care Manual page 9

Cycles, Options ondLights
Cycle Options
In addition to choosing a cycle from page 7, choose as many available options as are needed for your dishload.
ToughScrubV
ToughScrub T"Plus
(select models)
Sanitize
(select models)
Selected when washing loads with hard-to-remove food soils.
Depending on which cycle is being used, this option adds
heat and/or wash time to the wash cycle.
Sanitizes dishware. When cycle monitor recognizes that the
proper conditions have been met, SANITIZED light will activate
at the end of the cycle. Sanitization may not be achieved if
there is an interruption of the cycle, power failure or if the
incoming water temperature is below 120 ° F (/49° C).
Heavy Wash
Normal Wash
Light Wash
Auto Clean (select modelsJ
Heavy Wash*
Normal Wash*
Light Wash*
Auto Clean* (select models)
Extra Rinse Adds an additional rinse to cycle. An extra rinse helps to All cycles
(select models) improve results in hard water situations. (except Rinse Only)
Raises temperature in the final rinse to 160 ° F. This option can
160 ° Wash be used with any cycle except Quick Wash (select models) Heavy Wash
Normal Wash
(select models) and Rinse Only. Auto Clean* (select moaek_
Heated Dry
For enhanced drying results select this option. When Heated
Dry is not selected, towel drying of some items such as plastic
and items with non-stick surfaces may be necessary and more
moisture may be noticed adhering to the dishwasher interior.
In models with plastic interiors, it is normal to notice vapor
escaping from the door vent as the heat dries your dishes.
Vapor will escape even if Heated Dry is not selected.
All cycles
(except Rinse Only)
Only these cycles have been designated to meet NSF requirements (NSF/ANS1184 Residential Dishwashe0 fol sanitization.
Start/Cancel Starts and stops dishwasher. See page 2 under Operating Tips: All Cycles
Operating the Dishwasher, for explanation.
Used to automatically start the cycle at a later time. See page 9 All Cycles
Delay for instructions.
Control Lock Option Locks control touchpad to prevent unwanted use. See page 9 All Cycles
(select models) for instructions.
Cont.
8