Asus F2A85-V User Manual page 39

3. Serial ATA 6.0 Gb/s connectors (7-pin SATA6G_1~7)
These connectors are for the Serial ATA 6.0 Gb/s signal cables for Serial ATA hard
disk drives and optical disc drives. If you installed Serial ATA hard disk drives, you
can create a RAID 0, RAID 1, RAID 5, RAID 10, or JBOD configuration through the
onboard controller.
F2A85-V
F2A85-V SATA 6.0Gb/s connectors
• These connectors are set to AHCI mode by default. If you intend to create a Serial ATA
RAID set using these connectors, set the type of the SATA connectors in the BIOS to
[RAID]. See section 2.5.2 SATA Configuration for details.
• You must install Windows
ATA hard disk drives. The Serial ATA RAID feature is available only if you are using
Windows
• When using hot-plug and NCQ, set the type of the SATA connectors in the BIOS to
[AHCI]. See section 2.5.2 SATA Configuration for details.
4. Serial port connector (10-1 pin COM)
This connector is for a serial (COM) port. Connect the serial port module cable to this
connector, then install the module to a slot opening at the back of the system chassis.
F2A85-V
F2A85-V Serial port (COM) connector
The COM module is purchased separately.
ASUS F2A85-V
SATA6G_4 SATA6G_5
SATA6G_1
XP Service Pack 3 or later version before using Serial
®
XP SP3 or later version.
®
SATA6G_6 SATA6G_7
SATA6G_2 SATA6G_3
COM
PIN 1
1-27