Echo SB Safety Manual page 50

GLOSSARY
Head Protection
Hearing Protection Devices
Hedge Clipper
Idle Speed
Kickout
Manual Line Head
Maxi-Cut Blade
Maximum Diameter Cut
Muffler Housing
PAS
Power Head
Protective Clothing
Pruner
Purge Bulb
Push and Pull
Quick Release Latch
Rapid Loader Line Head
Rear Handle
50
Helmet-like device that protects the head from falling materials.
Protective devices such as ear plugs or ear muffs that protect
hearing by reducing exposure to harmful noises.
A cutting device with reciprocating blades. Used to cut
hedges, shrubs, and ornamental vegetation.
The normal running speed of the engine when the throttle
trigger is not depressed.
The sudden and forceful action that occurs when a blade
propels itself out of a cut due to binding or pinching of the
blade.
A line head that requires manual indexing of cutting line.
A cutting head with 3 straight blades that can be used in place
of a nylon line head. When the blade rotates, centrifugal force
causes the blades to fully extend, creating a wide cutting
swath.
The largest diameter material that can be cut by the cutting
attachment.
Provides protective barrier around muffler. Helps prevent
accidental contact with muffler when unit is hot.
Power Attachment Series - System consisting of an engine
power source, drive shaft, and a variety of optional work at-
tachments that can be changed as needed.
Engine assembly - includes engine, clutch, fuel system, ignition
system, air filter, and recoil starter.
Clothing that provides protection from work place hazards that
can cause cuts, scratches, or contact injuries.
A cutting device used to cut small limbs and branches from
trees, bushes, and shrubs.
Draws fuel mix from gas tank to carburetor. Helps engine to
start by removing air from fuel line.
Reactive forces that push the unit toward the operator, or that
pull the unit away from the operator.
A latch design that allows a quick separation of the unit from
the support harness when there is an emergency.
A line head that allows rapid nylon line reloading using short,
pre-cut pieces of line.
Houses Stop Switch, Throttle Trigger, and Throttle Trigger
lockout lever. Gripped by operator to help support unit, control
engine speed, and shut unit off.