Mower Drive Belt Installation - Craftsman 28947 - GT 5000 26 HP/54" Garden Tractor Operator's Manual

_] Right Side Rear Mower Bracket
' Hole
8 ATTACH FRONT LINK (E)
° Turn steering wheel to position wheels
straight forward.
• From front of tractor, insert rod end of
front link (E) through front hole in tractor
front suspension bracket (F).
o Move to left side of mower and and insert
large retainer spring (G) through hole in
front link (E) behind front suspension
bracket (F).
. Insert other end of link (E) into hole in
front mower bracket (H) and secure with
washer and small retainer spring (J)o
f
k(s)
[ D. Right Side Rear
NOTE: Requires deck lifting.
Front Link / !
Location, J s
9 INSTALL BELT ON ENGINE CLUTCH
PULLEY (M)
o Disengage belt tension rod (K) from
locking bracket (L).
• Install belt onto engine clutch pulley (M) o
IMPORTANT: Check belt for proper routing
in all mower pulley grooves and under
mandrel covers.
° Engage belt tension rod (K) on locking
bracket (L)_
_CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and engage
slowly.
° Raise attachment lift lever to highest
position.
o If necessary, adjust gauge wheels
before operating mower as shown in the
Operation section of this manual.
MOWER DRIVE BELT INSTALLATION
Follow procedure described in "TO
REPLACE MOWER BLADE DRIVE BELT"
in the "Service and Adjustments" section of
this manual.
:. Front Lift Link Assembly
F. Front Suspension Bracket
G, Large Retainer Spring
H_ Front Mower Bracket
J. Small Retainer Spring
M. Engine Clutch Pulley
11