Bosch WTVC533CUS Operating Manual page 16

4 wire installation installation
Thread the 4-wire cable
through the strain relief
clamp. Tighten the strain
relief clamp screws (2.5
Nm) so that the power
cord cannot be moved.
This will hold the power cord in
place and will make it easier to
correctly install the terminal
screws.
®
rq
Attach the power
cord ground
conductor (green)
to the GROUND
terminal. Tighten
the screw (2.5
Nm) so that the ..............
ground conductor
is held securely in
place.
Attach the 2 power cord outer
conductors (red and black,
either one can go left or right)
on the 2 terminals labeled L.
Attach the remaining power
cord conductor (white) to the
terminal labeled N.
Make sure the terminal screws align
properly with the terminal nuts to avoid
stripping the threads.
3 wire
@
®
D
Thread the 3-wire cable
through the strain relief
clamp. Tighten the strain
relief clamp screws (2.5
Nm) so that the power cord
cannot be moved.
This will hold the power cord in
place and will make it easier to
correctly install the terminal
screws.
Attach the 2 power
cord outer
conductors (red
and black, either
one can go left or
right) on the 2
terminals labeled
L. Attach the
remaining power
cord conductor
(white) to the
terminal labeled N.
Make sure the terminal
screws align properly with the
terminal nuts to avoid
stripping the threads.
t"
Tighten all 3 terminal screws (3 Nm) so that each
of the wires is held securely in place.
After tightening the screws, test to see that the terminals
are held securely in place to assure proper electrical
connection, otherwise a hazardous condition could
result.
Checkthe strain relief clamp to make sure that it
is tight and cannot be turned.
Replace the cover on the terminal block and
fasten it in place.
_E] ake sure the strain relief clamp is
outside the covert
The appliance is now ready to be plugged into a
properly rated receptacle.
16