Setting Up The Printer For Apple Macintosh Computers; When Using The Optional Rs-100M Serial Interface; When Using The Optional Br-Script 2 Rom Board Br-3000 - Brother HL1060 - B/W Laser Printer Service Manual

USER'S GUIDE

Setting Up the Printer for Apple Macintosh Computers

Question
I cannot print from my
application software.
Question
The printer does not print.
CHAPTER 6 –12

When Using the Optional RS-100M Serial Interface

Recommendation
Make sure that the supplied Macintosh printer
driver is installed in the System Folder and it is
selected with Chooser.
Check the PORT selection within the Chooser: it
should match the port to which you physically
attached the printer cable.
The serial slide switch of the optional interface
board should be in the Apple (RS-422A) position.
Check the printer cable type: you cannot use a
LocalTalk or straight-through cable. Refer to
Chapter 4

When Using the Optional BR-Script 2 ROM Board BR-3000

Recommendation
Check the following:
The printer is plugged in.
Paper is loaded.
No error conditions are active (any blinking lamps
on printer.)
Printer is on-line.
for details on printer cable type.