Cisco AP776A - Nexus Converged Network Switch 5020 Configuration Manual page 1341

Chapter 54 Configuring the Embedded Event Manager
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Command
action number [.number2] exceptionlog
module module syserr error devid id errtype
type errcode code phylayer layer ports list
harderror error [desc string]
action number[.number2] forceshut [module
slot | xbar xbar-number] reset-reason
seconds
action number[.number2] overbudgetshut
[module slot [- slot]]
action number[.number2] policy-default
action number[.number2] reload [module slot
[- slot]]
action number[.number2] snmp-trap
{[intdata1 data [intdata2 data] [strdata
string]}
action number[.number2] syslog [priority
prio-val] msg error-message
OL-18084-01, Cisco MDS NX-OS Release 4.x
Purpose
Logs an exception if the specific conditions are
encountered when an EEM applet is triggered.
Forces a module, crossbar, or the entire system to
shut down. The action label is in the format
number1.number2.
number can be any number up to 16 digits. The
range for number2 is from 0 to 9.
The slot range is dependent on different switches.
The xbar-number range is from 1 to 2 and is only
available on MDS 9513 modules.
The reset reason is a quoted alphanumeric string
up to 80 characters.
Forces one or more modules or the entire system
to shut down because of a power overbudget issue.
number can be any number up to 16 digits. The
range for number2 is from 0 to 9.
The slot range is dependent on different switches.
Executes the default action for the policy that you
are overriding. The action label is in the format
number1.number2.
number can be any number up to 16 digits. The
range for number2 is from 0 to 9.
Forces one or more modules or the entire system
to reload.
number can be any number up to 16 digits. The
range for number2 is from 0 to 9.
The slot range is dependent on different switches.
Sends an SNMP trap with the configured data.
number can be any number up to 16 digits. The
range for number2 is from 0 to 9.
The data arguments can by any number up to 80
digits. The string can be any alphanumeric string
up to 80 characters.
Sends a customized syslog message at the
configured priority.number can be any number up
to 16 digits. The range for number2 is from 0 to 9.
The error-message can be any quoted
alphanumeric string up to 80 characters.
Cisco MDS 9000 Family CLI Configuration Guide
Configuring EEM
54-9