Fan Module - Cisco AJ732A - MDS 9134 Fabric Switch Installation Manual

Nexus 5020 Switch
S e n d d o c u m e n t a t i o n c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
1
Table 1-2
Table 1-2
Power Supply Condition
No AC power to all power supplies.
Power supply failure, including over voltage, over current,
over temperature, and fan failure.
Power supply warning events where the power supply
continues to operate. These events include high
temperature, high power, and slow fan.
AC present, 3.3 voltage standby (VSB) on, and the power
supply unit is off.
Power supply on and OK.
If one power supply is installed in the chassis, but the other power supply slot is empty, a blank filler
panel should be used to cover the empty slot.
Figure 1-14

Fan Module

The Cisco Nexus 5020 switch has five fans modules.
Cisco Nexus 5000 Series Hardware Installation Guide
1-10
Green power LED indicates the power status. 2
table describes the status of the two power supply LEDs.
Power Supply LED Descriptions
Blank Power Supply Filler Panel
Amber fail LED indicates a failure condition.
Power LED Status
Off
Off
Off
1 Hz blinking
On
Figure 1-14 shows a blank power supply filler panel.
Figure 1-15 shows the fan module.
Chapter 1 Product Overview
Fail LED Status
Off
On
1 Hz Blinking
Off
Off
OL-15902-01