Deactivating And Purging A Cisco Sme Cluster - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Deactivating and Purging a Cisco SME Cluster

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
View the smart card information by selecting Smartcards.
Step 10
Deactivating and Purging a Cisco SME Cluster
You can archive clusters that are Online, Pending, or Deprecated. For information on cluster states, see
the
Archiving and then purging a Cisco SME cluster involves the following steps:
•
•
•
•
You can only purge a cluster that is in the deactivated state.
Note
This section covers the following topics:
Cisco MDS 9000 Family Storage Media Encryption Configuration Guide
4-20
"Viewing Cluster States" section on page
Delete all tape groups, tape devices, and tape volume groups (see
Configuration")
Delete all switches and Cisco SME interfaces from the cluster (see
Configuration")
Change the cluster state to deactivated (see
Purge (permanently delete) a Cisco SME cluster (see
Chapter 4
4-23.
Chapter 5, "Cisco SME Tape
Chapter 3, "Cisco SME Interface
Deactivating a Cisco SME Cluster, page
Purging a Cisco SME Cluster, page
OL-18091-01, Cisco MDS NX-OS Release 4.x
Cisco SME Cluster Management
4-21)
4-22)