Additional Switch Configuration; Assigning A Switch Name; Configuring Date, Time, And Time Zone - Cisco AJ732A - MDS 9134 Fabric Switch Configuration Manual

Chapter 3 Configuring the Switch
S e n d f e e d b a c k t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
•

Additional Switch Configuration

This section includes the following topics:
•
•
•

Assigning a Switch Name

Each switch in the network requires a unique name. You can assign names to easily identify the switch
by its physical location, its network association, or the organization to which it is deployed. The assigned
name is displayed in the command-line prompt. The switch name is limited to 20 alphanumeric
characters.
This guide refers to a switch in the Cisco Nexus 5000 Series switch as switch, and it uses the switch#
Note
prompt.
To change the name of the switch, perform this task:
Command
Step 1
switch# configure terminal
Step 2
switch(config)# switchname myswitch1
myswitch1(config)#
Step 3
myswitch1(config)# no switchname
switch(config)#

Configuring Date, Time, and Time Zone

The Cisco Nexus 5000 Series switches use Universal Coordinated Time (UTC), which is the same as
Greenwich Mean Time (GMT). To change the default time on the switch, perform this task:
Command
switch# clock set HH:MM:SS DD Month
YYYY
The following example sets the time for the switch:
switch# clock set 15:58:09 29 February 2008
Mon Feb 20 15:58:09 UTC 2008
OL-16597-01
Out-of-band access—You can use Telnet or SSH to access a Cisco Nexus 5000 Series switch or use
the Cisco MDS 9000 Fabric Manager application to connect to the switch using SNMP.
Assigning a Switch Name, page 3-13
Configuring Date, Time, and Time Zone, page 3-13
Adjusting for Daylight Saving Time or Summer Time, page 3-14
Purpose
Enters configuration mode.
Changes the switch name prompt as specified
(myswitch1).
Reverts the switch name prompt to its default (switch#).
Purpose
Sets the default time on the switch. HH represents hours
in 24-hour time (15 for 3 P.M.), MM is minutes (58), SS
is seconds (09), DD is the date (29), Month is the month
in words (February), and YYYY is the year (2008).
Cisco Nexus 5000 Series Switch CLI Software Configuration Guide

Additional Switch Configuration

3-13