10. Press down on the assembly. Make sure that the riser-card assembly is fully
11. Perform any configuration tasks that are required for the adapter.
If you have other devices to install or remove, do so now. Otherwise, go to
"Completing the installation" on page 111.
Removing a PCI adapter
To remove an adapter from a PCI riser-card assembly, complete the following steps.
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Turn off the server and peripheral devices and disconnect all power cords and
3. Press down on the left and right side rack latches and slide the server out of the
56
System x3650 M2 Types 4199 and 7947: Installation and User's Guide
v PCI riser connector 1: Carefully fit the two alignment slots on the side of the
assembly onto the two alignment brackets in the side of the chassis; align
the rear of the assembly with the guides on the rear of the server.
v PCI riser connector 2: Carefully align the bottom edge (the contact edge) of
the riser-card assembly with the PCI riser-card connector on the system
board; align the rear of the assembly with the guides on the rear of the
server.
seated in the PCI riser-card connector on the system board.
Adapter
Expansion-slot
cover
PCI
riser-card
assembly
on page 38.
external cables (see "Turning off the server" on page 22).
rack enclosure until both slide rails lock; then, remove the cover (see "Removing
the cover" on page 44).