Installing An Optional Cd-Rw/Dvd Drive; Completing The Installation - IBM 7947E3U User Manual

Installing an optional CD-RW/DVD drive

For a list of supported optional optical disk drives for the server, see
http://www.ibm.com/servers/eserver/serverproven/compat/us/.
To install an optional CD-RW/DVD drive, complete the following steps.
Alignment pins
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Make sure that the server is turned off, all external cables and power cords are
3. Remove the drive filler panel.
4. Attach the drive-retention clip to the side of the drive.
5. Slide the drive into the CD/DVD drive bay until the drive clicks into place.
If you have other devices to install or remove, do so now. Otherwise, go to

"Completing the installation."

Completing the installation
To complete the installation, complete the following steps:
1. If you removed the microprocessor 2 air baffle, replace the microprocessor 2 air
2. If you removed the DIMM air baffle, install it (see "Installing the DIMM air baffle"
3. If you removed either of the PCI riser-card assemblies, replace the riser-card
4. If you removed the server cover, replace it (see "Replacing the server cover" on
5. Install the server in a rack. See the Rack Installation Instructions that come with
6. To attach peripheral devices and connect the power cords, see "Connecting the
Drive retention clip
on page 38.
disconnected, and the cover has been removed. For more information, see
"Turning off the server" on page 22 and "Removing the cover" on page 44.
baffle (see "Installing the microprocessor 2 air baffle" on page 49 ).
on page 51).
assemblies (see "Installing a PCI riser-card assembly" on page 47).
page 112).
the server for complete rack installation and removal instructions.
external cables" on page 113.
Chapter 2. Installing optional devices
111