Installing The Sas Riser-Card And Controller Assembly - IBM 7947E3U User Manual

v Tape-enabled server model:

Installing the SAS riser-card and controller assembly

To install the SAS riser-card and controller assembly in the server, complete the
steps for the applicable server model.
v 12-drive-capable server model:
94
System x3650 M2 Types 4199 and 7947: Installation and User's Guide
1. Press down on the assembly release latch and lift up on the tab to release
the SAS controller assembly, which includes the SAS riser card, from the
system board.
2. Lift the front and back edges of the assembly to remove the assembly from
the server.
1. If you are replacing a ServeRAID-BR10il v2 SAS/SATA controller with a
ServeRAID-M5015/M5014 SAS/SATA controller, you have to swap the
controller retention brackets to fit the new SAS controller.