Layer 2 Ip Trunk Hash Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

Layer 2 IP Trunk Hash configuration

Trunk hash parameters are set globally for the HP 10GbE switch. You can enable one or two parameters,
to configure any of the following valid combinations:
SMAC (source MAC only)
DMAC (destination MAC only)
SIP (source IP only)
DIP (destination IP only)
SIP + DIP (source IP and destination IP)
SMAC + DMAC (source MAC and destination MAC)
The following table describes the IP Trunk Hash Configuration commands.
IP Trunk Hash Set commands
Table 114
Command
portchannel hash source-mac-
address
portchannel hash destination-mac-
address
portchannel hash source-ip-
address
portchannel hash destination-ip-
address
portchannel hash source-
destination-ip
portchannel hash source-
destination-mac
show portchannel hash
Description
Enable or disable trunk hashing on the source MAC.
Command mode: Global configuration
Enable or disable trunk hashing on the destination MAC.
Command mode: Global configuration
Enable or disable trunk hashing on the source IP.
Command mode: Global configuration
Enable or disable trunk hashing on the destination IP.
Command mode: Global configuration
Enable trunk hashing on the source and destination IP.
Command mode: Global configuration
Enable trunk hashing on the source and destination MAC address.
Command mode: Global configuration
Display current trunk hash configuration.
Command mode: All
Configuration Commands
139