Cist Port Configuration - HP 445860-B21 - 10Gb Ethernet BL-c Switch Reference Manual

CIST Bridge Configuration commands
Table 106
Command
spanning-tree mstp cist-
bridge forward-delay {<4-30>}
show spanning-tree mstp cist

CIST port configuration

CIST port parameters are used to modify MRST operation on an individual port basis. CIST parameters do
not affect operation of STP/PVST.
For each port, CIST is turned on by default. Port parameters include:
Port priority
Port path cost
Port Hello time
Link type
Edge
On and off
Current port configuration
The port option of MRST is turned on by default.
The following table describes the commands used to configure CIST Port Configuration commands.
CIST Port Configuration commands
Table 107
Command
spanning-tree mstp cist
interface-priority {<0-240>}
spanning-tree mstp cist path-
cost {<1-200000000>}
Description
Configures the CIST bridge forward delay parameter. The forward delay
parameter specifies the amount of time that a bridge port has to wait
before it changes from the listening state to the learning state and from
the learning state to the forwarding state. The range is 4 to 30 seconds,
and the default is 15 seconds.
This command does not apply to RSTP. See the "Bridge Spanning Tree
configuration" section for more information.
Command mode: Global configuration
Displays the current CIST bridge configuration.
Command mode: All
Description
Configures the CIST port priority. The port priority helps determine
which bridge port becomes the designated port. In a network
topology that has multiple bridge ports connected to a single segment,
the port with the lowest port priority becomes the designated port for
the segment. The range is 0 to 240, in steps of 16 (0, 16, 32...), and
the default is 128.
Command mode: Interface port
Configures the CIST port path cost. The port path cost is used to help
determine the designated port for a segment. Generally speaking, the
faster the port, the lower the path cost. The default for Gigabit ports is
20000, and for 10Gb ports is 2000.
Command mode: Interface port
Configuration Commands
132