Power On/Off; Specifications; Connecting And Positioning - Panasonic SH-FX50 - HOME THEATER SOUND Operating Instructions Manual

Connecting and positioning

Preparation
≥Turn off all equipment before connection and read the appropriate operating instructions.
≥Connect the AC power supply cord after all other connections are complete.
Connecting the digital transmitter
Insert the digital transmitter into the slot.
Digital transmitter
Insert fully until you
hear a click.
Connecting the surround speaker cables
to the digital receiver
1
If the surround speaker cables have already been connected
Disconnect the surround speaker cables from
the subwoofer.
2
Connect the surround speaker cables to the
receiver.
1
2
Flip the tab open.
L
R
3
Surround
cable (L)

Power on/off

Refer also to the operating instructions for your home theater system.
1
Power on your home theater system.
2
Power on the receiver.
Wireless link indicator
This indicator lights when the signal strength is
adequate for proper operation.
Power indicator
This indicator lights when the unit is turned on.
Power on/off button
Press!
3
Start play on your home theater system.
Do not insert or
remove while your
home theater
system is on.
Rear of your home theater system
Insert the cable into the
terminal.
Color of the cables
AC IN~
i: White or Copper
j: Blue or Silver
Flip the tab closed.
AC power
Click! supply cord
To household AC outlet (AC 120 V, 60 Hz)
" [W] " lights up in the display on
your home theater system.
(" [W] " is flashing ➜ page 1,
Troubleshooting guide)
∫ Wireless setup diagram
e.g.
Home theater main unit
≥Place the digital receiver within approximately 10 m (33 feet) from the home
theater main unit.
[Note[
≥Do not use more than two surround speakers when using this wireless
system.
≥Do not use this wireless system near a microwave oven.
≥Do not place the transmitter or receiver in a metal cabinet or bookshelf.

Specifications

RF SECTION
Wireless module
Frequency range
No. of channels
Bandwidth/Channel
RF output power
RF output impedance
Type of emissions
Data rate
AMPLIFIER SECTION
W
Output power
RMS output power
Surround Ch
FTC output power
Surround Ch
GENERAL
Power supply
Power consumption
Dimensions (WtHtD)
Digital transmitter
Digital receiver
Mass
Digital transmitter
Digital receiver
Operating temperature range
Operating humidity range
[Note]
1. Specifications are subject to change without notice.
Mass and dimensions are approximate.
2. Total harmonic distortion is measured by a digital spectrum analyzer.
4
Digital receiver
Surround speaker
cables
2.402 to 2.480 GHz
14 dBm (Max)
70 W per channel (4 ≠), 1 kHz, 10 % THD
45 W per channel (4 ≠), 20 Hz–20 kHz, 1 % THD
AC 120 V, 60 Hz
Digital transmitter
Digital receiver
97 mmk47.5 mmk8.5 mm (3.8zk1.9zk0.3z)
103 mmk215 mmk178 mm (4zk8.5zk7.0z)
0.03 kg (0.07 Ibs)
2.1 kg (4.6 Ibs)
r5 oC to r35 oC (r41 oF to r95 oF)
5 % to 90 % RH (no condensation)
79
1 MHz
50 ≠
1 Mbps
0.3 W
35 W