Table of Contents
Advertisement
3.
Insert the hard disk drive into the
HDD bracket and secure it with four
screws.
4.
Connect the SATA signal cable and
a power plug from the power supply
to the hard disk drive.
Use the L-type SATA connector
to connect to the hard disk drive.
5.
Place the HDD bracket with the
hard disk drive installed into the
HDD tray 2, matching the four
screw holes. Then, secure the HDD
bracket with four screws.
Refer to section 2.7.2 Optical disk drive (ODD) to reinstall the ODD.
6.
2-14
L-type SATA
connector
Power plug
SATA signal cable
Chapter 2: Hardware setup
Advertisement
Table of Contents
