Audio Connections; Network Connections - EAW UX8800 Owner's Manual

4 . 3
4.3.1
Use a good quality, 2-conductor shielded cable for all audio input and output connections.
4.3.2
The four, female, XLR-type connectors labeled A through D are audio input connectors.
NOTES:
Analog Pin-Out: XLR A to XLR D
Electronically balanced, line level
AES/EBU Pin-Out: XLR A and XLR C
Transformer isolated, balanced.
4.3.3
The eight, male, XLR-type connectors labeled 1 through 8 are the audio output connectors.
Analog: XLR 1 to XLR 8
Electronically balanced, line level.
2
1 Shield
3-
OUTPUT (analog) INPUT (analog)
4 . 4
4.4.1
The UX8800 communicates with a computer through its built-in, front panel, Ethernet port. This port is
U-NET
configured as a standard NIC (network interface card). The UX8800 can be connected to an Ethernet
1 network using hub, switch, router, or wireless connections.
ETHERNET ETHERNET
2
A u d i o C o n n e c t i o n s
SIGNAL CABLE
INPUT CONNECTIONS
1. Select the signal type, analog or AES/EBU, in the hardware Utilities menu or
EAWPilot/UX8800 settings window.
2. XLR connector B is inactive when AES/EBU is selected for XLR connector A & B.
3. XLR connector D is inactive when AES/EBU is selected for XLR connector C & D.
Pin 1: Shield
Pin 2: + (plus or high)
Pin 3: - (minus or low)
Pin 1: Signal ground (shield)
Pin 2: Channel 1
Pin 3: Channel 2
OUTPUT CONNECTIONS
Pin 1: shield
Pin 2: + (plus or high)
Pin 3: - (minus or low)
1
D
PUSH
ANALOG ANALOG/AES
2+ 2+ 3-
N e t w o r k C o n n e c t i o n s
ETHERNET
Cable:
Mating Connector:
Wiring Configuration:
B
PUSH
C
PUSH
1 Shield
ANALOG
2 Signal
INPUT (digital - AES/EBU)
8 conductor CAT-5 or better
RJ-45 male
Standard for connection to a network hub, switch, or router
Crossover type for direct connection to a computer's NIC
Page 6
A
PUSH
1 Signal Earth
(cable shield)
ANALOG/AES
3 Signal