Configuring Auto Voip (Cli) - Dell PowerConnect 7048P Manual

Configuring Auto VoIP (CLI)

This section provides information about the commands you use to configure
Auto VoIP settings on the switch. For more information about the
commands, see the
Mapping Table Configuration
Beginning in Privileged Exec mode, use the following commands in to enable
Auto VoIP and view its configuration.
CLI Command
configure
switchport voice detect auto
exit
exit
show switchport voice
PowerConnect 7000 Series CLI Reference Guide
Description
Enter Global Configuration mode.
Enable the VoIP Profile on all the interfaces of the
switch. You can also enter Interface Configuration
mode and use the same command to enable it on a
specific interface.
Exit to Global Configuration Exec mode.
Exit to Privilege Exec mode.
Show the status of Auto-VoIP on all interfaces or on
an interface, if one is specified.
Configuring Auto VoIP
.
1135