Port-Based Network Access Control; 802.1X Authenticator Parameter - D-Link DGS-3048 - Switch Product Manual

DGS-3048 Gigabit Ethernet Switch Manual

Port-Based Network Access Control

The original intent behind the development of 802.1x was to leverage the characteristics of point-to-point in LANs. Any
single LAN segment in such an infrastructures has no more than two devices attached to it, one of which is a Bridge Port.
The Bridge Port detects events that indicate the attachment of an active device at the remote end of the link, or an active
device becoming inactive. These events can be used to control the authorization state of the Port and initiate the process of
authenticating the attached device if the Port is unauthorized. This is the Port-Based Network Access Control.
RADIUS
Server
Ethernet Switch
...
802.1X 802.1X 802.1X 802.1X 802.1X 802.1X 802.1X
802.1X 802.1X
Client Client Client Client Client Client Client
Client Client
Network access controlled port
Network access uncontrolled port
Figure 10- 6. Example of Typical Port-Based Configuration
Once the connected Client has successfully been authenticated, the Port then becomes Authorized, and all subsequent traffic
on the Port is not subject to access control restriction until an event occurs that causes the Port to become Unauthorized.
Hence, if the Port is actually connected to a shared media LAN segment with more than one attached device, successfully
authenticating one of the attached devices effectively provides access to the LAN for all devices on the shared segment.
Clearly, the security offered in this situation is open to attack.

802.1x Authenticator Parameter

To configure the 802.1x Authenticator Settings, click Configure 802.1x Authenticator Parameter
81