Chapter 1
Setting Up the Printer
Unpacking
The illustration below shows the items included for the standard
specification printer.
Ribbon cassette
Spacers for the paper roll
near-end sensor 2 pcs
(*1) The power cord may not be included in the package. If it is not, make sure to use a
power cord that complies with the safety standards.
If any item is damaged, please contact your dealer for assistance.
Selecting a Location
Place the printer on a surface that is as horizontal as possible. Make
sure that the printer does not tilt more than 15 degrees.
The printer should be installed so that it does not move or vibrate
during paper cutting or the drawer kick-out operation.
Fastening tape is available as an option.
Printer
Paper roll
Power supply
Manual
Power switch cover
Setting Up the Printer 1–1
*
1