xStack DES-3500 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
Initializing Ports for MAC Based 802.1x
To initialize ports for the MAC side of 802.1x, the user must first enable 802.1x by MAC address in the Advanced Settings
window. Click Configuration > Port Access Entity > PAE System Control > Initialize Port(s) to open the following window:
To initialize ports, first choose the range of ports in the From and To field. Then the user must specify the MAC address to be
initialized by entering it into the MAC Address field and checking the corresponding check box. To begin the initialization, click
Apply.
Reauthenticate Port(s) for Port Based 802.1x
This window allows you to reauthenticate a port or group of ports by choosing a port or group of ports by using the pull down
menus From and To and clicking Apply. The Reauthenticate Port Table displays the current status of the reauthenticated port(s)
once you have clicked Apply.
Click Configuration > Port Access Entity > PAE System Control > Reauthenticate Port(s) to open the Reauthenticate Port(s)
window:
This window displays the following information:
Figure 6- 93. Initialize Port(s) window (MAC based 802.1x)
NOTE: The user must first globally enable 802.1X in the Switch Information
(Advanced Settings) window in the Configuration folder before initializing ports.
Information in the Initialize Ports Table cannot be viewed before enabling 802.1X.
Figure 6- 94. Reauthenticate Port window
111