Bosch SHX6AP05UC - 24' Ascenta Series Dishwasher Use And Care Manual page 15

2. Return thelocking n uttoitsinstalled position a nd turnit 1/8 turnclockwise.
3. Return thetoprack tothetoprack roller g uides.
Toremove t hebottom spray arm:
1. Remove theempty bottom rack from thedishwasher tub.
2. Grasp a ndliftthebottom spray a rmasshown i nFigure 1 9.
3. Look f orobstruction inthespray n ozzles.
4. If thespray n ozzles need cleaning, flush them under running w ater.
Toreinstall thebottom spray a rm:
1. Return t hebottom spray a rmto itsinstalled p osition a ndpress i t sothatit snaps i nto
place.
2. Return thebottom rack toitsinstalled position.
Check/Clean the Filter System
This dishwasher has a filter system that consists of a Large Object Trap/Cylinder Filter assembly
and a Fine Filter, Select models have an additional Micro Filter, The filter system is located on the
inside of your dishwasher under the lower rack and is easily accessible,
During normal use, the filter system is self-cleaning. You should occasionally inspect it for foreign
objects and clean it when necessary.
,CAUTION
To avoid injury, do not reach into the large object trap with your fingers. The large object
trap could contain sharp objects.
To Remove the Large Object Trap/Cylinder Filter Assembly:
1. Remove the bottom rack.
2. Grasp the assembly as shown in Figure 20 and turn it counter clockwise 1/4 turn.
3. Lift out the assembly as shown in Figure 21 and 22.
4. Carefully examine the assembly. If you find debris in the Large Object Trap, turn it upside-down
and gently tap it on a surface such as a countertop to dislodge and remove the debris. Flush
the Cylinder Filter clean by holding it under running water. Place parts back in unit and lock
as shown in Figure 23.
Figure 20
To open - turn counterclockwise.
Figure 21
Large Object Trap
Figure 22
Figure 23
To close - turn clockwise.
15