Flashing Display Lights - Hotpoint HDA3600RWW - 24 in. Dishwasher Owner's Manual

Operation of electronic models (model GSD4000 Only)
Using the Dishwasher Door
door must be closed and locked into place to select a LOADSELECTIONor an OPTION.
Ifthe door is opened during a cgcle and left open, the dishwasher willbeep once every 30 seconds until the
.... door is cosed and atched into p ace.
Start
Close and latch the door. Touch the START/RESET pod to begin the cgcle. Water fill begins and
opproximatelg 60 seconds later the wash action begins.
NOTE:The dishwasher remembers gour last cgcle so gou don't hove to reprogram each time. When
the dishwasher is loaded and the door latch is in the locked position, the control panel lights will be ON
and displag the last settings gou selected.
If gou don't wont to change ang of the settings, simplg touch the START/RESET pad to begin
the cgcle.
Also, if a power failure occurs, NORMAL and HEATEDDRY will automatically be programmed.
Hake ang new selections and touch the START/RESET pad to begin the cgcle.
Cleon
This light is illuminated when o wash cgcle is complete. The light will stag ON until the door is opened.
Flashing Display Lights
Lights
What It Means
This is normal.
The START/RESET pad
has been pressed.
What To Do
Allow the dishwasher to drain and reset before gou start a new
wash cgcle.
CLEAN
PLUS A
BEEPING
SOUND
Control Error
Pressthe START/RESET p ad to turn off the beeper. If the CLEAN
light continues to flash, coil for service.
Control Error
Pressthe START/RESET p ad to turn off the beeper and the
dishwasher will attempt to reset. Restart the wash cgcle.
If this error continues, turn off the power to the dishwasher at
the circuit breaker for 30 seconds. Trg the dishwasher again.
If the error is still present, coil for service.
PLUS A
BEEPING
SOUND
10