Table of Contents
Advertisement
Care and maintenance instructions
Drain pump
The pump can be accessed from inside the
dishwasher.
1. Cut the power to the dishwasher by unplugging
the unit from the power outlet.
2. Remove the coarse filter and pipe section.
3. Remove the small yellow drain pump access cover
at the left of the bottom drain (see illustration
below).
4. By inserting your finger into the hole, you can turn
the pump blades to release anything blocking the
pump.
5. Reinstall the access cover and filters.
6. Plug the machine in again.
If the dishwasher still does not start and a whirring
sound is heard, the overflow protection has been
triggered.
• Shut off the water.
• Unplug the unit from the power outlet.
• Call the Customer Care Center.
NOTE!
Do not forget to reinstall the drain pump access
cover.
Lower spray arm
Holes and bearings can sometimes become blocked.
1. Pull the lower spray arm straight up to release it.
2. Remove any debris using a needle, toothpick, or
some other similar pointed device. The spray arms
also have holes underneath.
Upper spray arm
The upper basket must be removed before the upper
spray arm can be released.
1. Pull out the upper basket and turn the basket catch
on each runner outward (see illustration). The
basket can now be removed.
2. Loosen the upper spray arm in the same manner
as the lower spray arm and clean it.
Customer Care Center
1-800-898-1879
www.askousa.com
21
Hide quick links:
Advertisement
Table of Contents
