Using The Power Saving Function - Pentax Optio E90 Red Operating Manual

Using the Power Saving Function

You can save battery power by setting the display to dim automatically
when no operation is performed for a fixed time. After the power saving
function has been activated, the display returns to the ordinary
brightness by pressing any of the buttons.
1
Press the 3 button in Q mode.
[W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2
Use the four-way controller (23) to select [Power
Saving].
3
Press the four-way controller (5).
A pull-down menu appears.
4
Use the four-way controller (23)
to select the time until the camera
enters power saving mode.
Choose from [2min.], [1min.], [30sec.],
[15sec.], [5sec.] or [Off.].
5
Press the 4 button.
The setting is saved.
• Power Saving does not function in the following situations:
- in the playback mode
- while recording a movie
- while the camera is connected to a computer
- while a menu is being displayed
• When no operation is performed after the camera is turned on, Power
Saving is activated only after 15 seconds elapse even if [5sec.] is set.
Setting
Video Out
2min.
Brightness Level 1min.
Power Saving
30sec.
Auto Power Off 15sec.
Reset 5sec.
Off
Delete all
MENU Cancel Cancel Cancel
2/3
6
OK OK OK OK
151