Pioneer HTS-560DV Operating Instructions Manual page 11

Connecting up
3 Assemble the AM loop antenna.
a
b
c
a. Bend the stand in the direction indicated by the
arrow.
b. Clip the loop onto the stand.
c. If you want to fix to a wall or other surface, perform
step b after first securing the stand with screws.
It is recommended that you determine the reception
strength before securing the stand with the screws.
4 Connect the AM and FM antennas
a. Connect one wire of the AM loop antenna to each AM
2
antenna terminal .
For each terminal, press down on the tab to open;
insert the wire, then release to secure.
1
3
b. Push the FM antenna plug onto the center pin of the
FM antenna socket.
Note
1 • Keep antenna cables away from other cables, the display unit, receiver subwoofer and DVD player.
• If reception with the supplied antenna is poor, see Improving poor FM reception and Improving poor AM sound on page 25 or Connecting
external antennas on page 29.
2 • Don't let it come into contact with metal objects and avoid placing near computers, television sets or other electrical appliances.
• The signal earth ( ) is designed to reduce noise that occurs when an antenna is connected. It is not an electrical safety earth.
• If radio reception is poor, you may be able improve it by re-inserting each antenna wire into the opposite terminal.
• For best reception, do not untwist the AM loop antenna wires or wrap them around the loop antenna.
3 • To ensure optimum reception, make sure the FM antenna is fully extended and not coiled or hanging at the rear of the unit.
1
.
2
5 Connect each speaker.
• Each speaker cable has a color-coded connector at
one end and two wires at the other end.
Color-coded connector
(Connect to rear panel)
• Twist and pull off the protective shields on each wire.
• Connect the wires to the speaker. Match the colored
wired with the color-coded label (model label), then
insert the colored wire into the red (+) side and the
other wire into the black (–) side.
• Connect the other end to the color-coded speaker
terminals on the rear of the receiver subwoofer. Make
sure to insert completely.
The small lug at the wire-end of the speaker plug
should face up or down depending on whether it's
being plugged into one of the upper or lower speaker
terminals. Please make sure to connect correctly.
Upper terminal
6 Connect the subwoofer cable.
• Just below the subwoofer speaker, to the left of
center, you should see the subwoofer connecting
cable. Plug this into the SUBWOOFER SPEAKER
terminal.
Color-coded wire
(Connect to speaker)
Lower terminal
02
11
En