Pentax 17731 Operating Manual page 144

• Confirm that the battery is sufficiently charged before starting interval
movie recording. If the battery is not sufficiently charged, it may
become depleted during interval movie recording and cause recording
of the movie to stop.
• When performing interval movie shooting, the settings are fixed as
follows; Recorded Pixels: m, Quality Level: C, Movie SR: P (Off),
and Flash Mode: a. However, shooting is done at a frame rate
according to the recorded pixels (p.138) set on the Movie menu.
• Interval Shoot stops if the SD Memory Card is removed or inserted
during standby.
• If you set a start delay, a start time corresponding to the current time
3
and the start delay you set is displayed in real time.
• The total time you can set differs according to the shooting interval you
set, as indicated in the table below.
Interval
142
10 minutes to 5 hours and 59
1 min
(in increments of 1 minute)
30 minutes to 29 hours and
5 min 55 minutes
(in increments of 5 minutes)
1 hour to 59 hours and 50
10 min
(in increments of 10 minutes)
3 hours to 179 hours and 30
30 min
(in increments of 30 minutes)
6 hours to 359 hours
1 hr
(in increments of 1 hour)
Total time that can be set
30 fps
minutes
minutes
minutes
15 fps
10 minutes to 5 hours and 59
minutes
(in increments of 1 minute)
15 minutes to 29 hours and 55
minutes
(in increments of 5 minutes)
30 minutes to 59 hours and 50
minutes
(in increments of 10 minutes)
1 hour and 30 minutes to 179
hours and 30 minutes
(in increments of 30 minutes)
3 hours to 359 hours
(in increments of 1 hour)