Installing Batteries In The Remote Control; Using The Remote Control - Insignia NS-HT511 User Manual

Insignia NS-HT511 Home Theater System
• When successfully joined, the power indicator
LED on your other Rocketboost device will
stop blinking and stay on.
• If joining fails after 30 seconds, the display on
your surround sound receiver shows
"Timeout. " If this occurs, repeat the above
steps.
Listening to music from other Rocketboost™ products
To listen to music:
1 Press the Power button on your surround sound
receiver to turn it on.
2 Press SETUP. The Setup Menu opens.
Setup Menu
1. HDMI Input
2. Component
3. Digital Audio
4. Sp Config
5. Sp Distance
6. Level Cal
7. Audio Adjust
8. Source Setup
9. Hardware
10. HDMI Setup
11. Rocketboost
3 Press or to select 11. Rocketboost, then
press ENTER. The Rocketboost menu opens.
Rocketboost
Send Wireless Audio
Listen to Wireless Audio
Connect to Wireless Network
Hub ( Manager ) Enable
4 Press or to select Listen to Wireless
Audio, then press ENTER. The Listen to Audio
menu opens.
Listen to Audio
RF-RBAUX ( Audio In )
[ ENTER ] to Select
5 Press or to highlight the Rocketboost
device you want to listen to, then press ENTER
to select it.
Rocketboost Network Capabilities

Installing batteries in the remote control

Using the remote control

[ Selected ]
www.insigniaproducts.com
The maximum number of Rocketboost devices in a
Rocketboost Network is nine. If you already have
nine and attempt to join an additional device,
joining will fail for the new device.
Note
If you want to remove a device from your
Rocketboost network you need to rejoin it to a
different hub device (this basically creates a 2nd
Rocketboost network).
The maximum number of audio streams that can be
sent simultaneously on the Rocketboost network is
five (stereo CD quality).
Cautions
• If the remote control doesn't work reliably, try
replacing the batteries.
• Don't mix new and old batteries or different
types of batteries.
• If you intend not to use the remote control for a
long time, remove the batteries to prevent
damage from leakage or corrosion.
• Remove expired batteries as soon as possible to
prevent damage from leakage or corrosion.
To install the batteries:
1 Remove the cover.
Batteries (AA/R6)
2 Insert two AA batteries into the compartment
matching the polarity indicated.
3 Replace the cover.
Use the remote control by pointing it towards the
receiver's remote sensor window. Objects between
the remote control and sensor window may
prevent proper operation.
Remote control sensor
Receiver
Approx. 16 ft. (5 m)
15