Removing An Internal 3.5-Inch Hard Drive - HP dx7510 - Microtower PC Service & Reference Manual

NOTE:
board drive connectors.
10. Replace the front bezel and access panel.
11. Lock any security devices that were disengaged when the access panel was removed.

Removing an Internal 3.5-inch Hard Drive

NOTE: Before you remove the old hard drive, be sure to back up the data from the old hard drive so
that you can transfer the data to the new hard drive. Also, if you are replacing the primary hard drive,
make sure you have created a Recovery Disc Set to restore the operating system, software drivers, and
any software applications that were preinstalled on the computer. If you do not have this CD set,
select Start > HP Backup and Recovery and create it now.
1. Prepare the computer for disassembly
2. Remove the access panel
3. Lay the computer on its side with the front facing toward you.
4. Remove the two screws that secure the hard drive cage to the chassis.
Figure 6-24
54 Chapter 6 Removal and Replacement Procedures Microtower (MT) Chassis
Refer to System Board Drive Connections on page 48
(Access Panel on page
Removing the Hard Drive Cage Screws
(Preparation for Disassembly on page
33).
for an illustration of the system
32).