Computer Setup-Hardware Monitor Setup - HP dx7510 - Microtower PC Service & Reference Manual

Table 2-8 Computer Setup—PnP/PCI Configurations (continued)
Reset Configuration
Data
Resources Controlled
By
IRQ Resources
●
IRQ-3 assigned to
● IRQ-4 assigned to
●
IRQ-5 assigned to
●
IRQ-7 assigned to
●
IRQ-9 assigned to
●
IRQ-10 assigned to
●
IRQ-11 assigned to
●
IRQ-12 assigned to
●
IRQ-14 assigned to
●
IRQ-15 assigned to
Computer Setup—Hardware Monitor Setup
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table 2-9 Computer Setup—Hardware Monitor Setup
Option
Reset Case Open
Status
Fan Controller
CPU Fan Speed
System Fan Speed
CPU Fan Fault Detect
SYS Fan Fault Detect
Disables/enables automatic reconfiguration.
The default is Disabled. Select Enabled to reset Extended System Configuration Data (ESCD) when
you exit Setup, if you have installed a new add-on and the system reconfiguration has caused such
a serious conflict that the OS cannot boot.
Allows you to select whether resources are controlled automatically or manually:
● Auto (ESCD–Extended Storage Configuration Data)
●
Manual
BIOS can automatically configure all the bootable and Plug-and-Play-compatible devices. If you
choose Auto, you cannot select IRQ, DMA and memory base address fields since BIOS
automatically assigns them.
When resources are controlled manually, allows you to assign each system interrupt a type,
depending on the type of device using the interrupt.
Legacy ISA for devices compliant with the original PC AT bus specification, PCI/ISA PnP for devices
compliant with the Plug-and-Play standard whether designed for PCI or ISA bus architecture.
Description
Disables/enables resetting of the case open status.
Disables/enables auto fan control mode.
(view only)
(view only)
Disables/enables detection of CPU failure during POST.
Disables/enables detection of fan failure during POST.
Computer Setup (F10) Utilities 11