Battery Cable - TomTom RIDER 2nd Edition User Manual

Battery cable

Taking care of your TomTom RIDER
•
•
•
16
•
•
•
3. Close the Holder. Make sure that your RIDER is held firmly in place.
You are now ready to make your first trip with your TomTom RIDER.
The battery cable can optionally be used to power and charge your
TomTom RIDER from your motorcycle battery.
Note: If you are unsure about setting up the battery cable, consult your local
motorcycle garage.
Connect the battery cable connector to the power connector on the holder.
Connect the red battery cable to the switched positive 12 volt power supply
on your motorcycle and the black battery cable to the ground supply on your
motorcycle.
Make sure that the battery cable is secured safely to your motorcycle. It must
not hang from the frame or interfere with the motorcycle in any way. Make
sure that it is also not in contact with any areas of the motorcycle that become
hot and may melt the cable.
It is important to take care of your RIDER and to clean it correctly.
• Use the screen cloth provided to wipe the screen of your RIDER; do not use
any liquid cleaners.
• Only open the compartment that contains the memory card slot when you
are indoors. Do not open the compartment when your RIDER is wet.
• When carrying your RIDER, always use the RIDER case provided.
• If your RIDER gets wet, dry it with a soft cloth.
• Do not open the casing of your RIDER under any circumstances.
• Do not use the memory card (SD card) with any device other than your
RIDER. Other devices may damage the memory card.