Compaq dx2390 - Microtower PC Service & Reference Manual page 57

Business pc

Hide thumbs Also See for dx2390 - Microtower PC:

Table of Contents

Slide the drive in through the front of the chassis (1) until the bezel on the drive is evenly aligned

with the computer front bezel and install the M3 metric retainer screws (2) as shown in the

illustration below.

NOTE:

Extra drive retainer screws are provided on the interior of the front bezel if needed. The

M3 metric retainer screws for diskette drives or media card readers are black.

Connect the appropriate drive cables:

If installing a diskette drive, connect the power and data cables to the rear of the drive and

connect the other end of the data cable to the connector on the system board labeled FDD1.

If installing a media card reader, connect the USB cable from the media card reader to the

USB connector on the system board labeled JUSB2.

NOTE:

Refer to

board drive connectors.

Replace the front bezel and access panel.

10.

Lock any security devices that were disengaged when the access panel was removed.

System Board Drive Connections on page 44

for an illustration of the system

Drives

Table of Contents