Compaq dx2390 - Microtower PC Service & Reference Manual page 47

Business pc

Hide thumbs Also See for dx2390 - Microtower PC:

Table of Contents

To install a new expansion card, hold the card just above the expansion socket on the system

board then move the card toward the rear of the chassis so that the bottom of the bracket on the

card slides into the small slot on the chassis. Press the card straight down into the expansion socket

on the system board.

NOTE:

When installing an expansion card, press firmly on the card so that the whole connector

seats properly in the expansion card slot.

Replace the slot cover lock and secure it in place with the screw that was previously removed.

10.

Connect external cables to the installed card, if needed. Connect internal cables to the system

board, if needed.

11.

Reconfigure the computer, if necessary. Refer to

instructions on using Computer Setup.

Computer Setup (F10) Utility on page 3

for

Expansion Cards

Table of Contents