VTech CS6328-3 Quick Start Manual
User manual
Hide thumbs
Also See for CS6328-3:
- User manual (22 pages) ,
- User manual (72 pages) ,
- Quick start manual (7 pages)
Table of Contents
Advertisement
Quick start guide
CS6328-2/CS6328-3/CS6328-4/
CS6328-5/CS6329/CS6329-2/
CS6329-3/CS6329-4/CS6329-5
Introduction
This quick start guide provides you with the basic installation
and use instructions. A limited set of features are described in
abbreviated form.
Please refer to the user's manual for complete installation and
operation instructions.
Telephone base and charger installation
Install the telephone base and charger(s) as shown below.
Charger adapter
Charger
Use only the power adapter(s) and battery(ies) supplied with
this product.
Battery installation and charging
Install the battery as shown below. Once you have installed the
battery, you may be able to make and receive short calls. For
best performance, charge the handset battery continuously for at
least 6 hours.
Plug the battery connector
securely into the socket.
3 Slide the battery
compartment towards the
center of the handset until it
clicks into place.
Telephone base
power adapter
Electrical outlet
not controlled by
a wall switch
Charge light
remains on
when charging.
Telephone base
2 Place the battery with the
wires inside the battery
compartment.
4 Charge the handset in the
telephone base.
Telephone
wall jack
If you have DSL
high speed Internet
service, a DSL filter
(not included) is
required.
Telephone line cord
Advertisement
Table of Contents
Related Manuals for VTech CS6328-3
Summary of Contents for VTech CS6328-3
-
Page 1: Quick Start Guide
Quick start guide CS6328-2/CS6328-3/CS6328-4/ CS6328-5/CS6329/CS6329-2/ CS6329-3/CS6329-4/CS6329-5 Introduction This quick start guide provides you with the basic installation and use instructions. A limited set of features are described in abbreviated form. Please refer to the user’s manual for complete installation and operation instructions. -
Page 2: Handset Overview
handset overview Charge light MeNU/SeLeCT On when the handset Show the menu. is charging. Select an item or save a setting while in a (speakerphone) menu. Make or answer a call. VOL/ Switch between (volume/directory) speakerphone and handset during a call. Review the directory when the telephone is VOL/CID... -
Page 3: Telephone Settings
Using the menu To enter the handset menu: The > symbol indicates the Press MeNU/ when the telephone is SeLeCT feature to select. not in use. >RINGERS VOL/ VOL/ Press until the SEttINGS > symbol displays next to the desired feature menu. -
Page 4: Menu /Select
Intercom Use the intercom feature for conversation between two system handsets. • You can use a maximum of four handsets at a time. When two handsets are used on an intercom call, use two other system handsets for an outside call. •... -
Page 5: Call Log
Speed dial You can store up to 0 telephone numbers with names in the speed dial memory locations you assign from the directory. The speed dial memory locations are shared by all handsets. To store a speed dial entry: Press MeNU/ when the handset is not in use. -
Page 6: Answering System Settings
about answering system and voicemail Your telephone has separate indicators for two different types of voice messages: those left on the built-in answering system and those left at your telephone service provider’s voicemail. Each alerts you to new messages separately. and New VOICeMaIL display on the handset, your •... -
Page 7: Play Messages
Play messages To play messages with the telephone base: /PLaY/ Press when the telephone is not in use. STOP Options during playback: /VOL+ or /VOL- to adjust the speaker volume. • Press Press /SKIP to skip to the next message. •...