Adjusting The Dip Switches; Changing The Dip Switch Settings - Epson H6000III - TM Two-color Thermal Line Technical Reference Manual

3.4.3 Adjusting the DIP Switches

The printer has two sets of DIP switches. The function of the DIP switches is different for each
interface model.

3.4.3.1 Changing the DIP Switch Settings

If you need to change settings, follow the steps below to make your changes:
CAUTION:
Turn off the power while removing the DIP switch cover to prevent an electric short,
which can damage the printer.
Use a crosshead screwdriver to remove the screw holding the DIP switch cover.
1. Make sure the printer is turned off.
2. Remove the screw from the DIP switch cover. Then take off the DIP switch cover.
DIP switch cover
3. Set switches using a pointed tool, such as tweezers or a small screwdriver.
4. Replace the DIP switch cover. Then secure it with the screw.
The new settings take effect when you turn on the printer.
Note:
The functions of the switches of are shown in the following sections.
Rev. E
TM-H6000III Technical Reference Guide
switches
Setup 3-19