Adjusting The Dip Switches; Changing The Dip Switch Settings - Epson TM H6000 - B/W Direct Thermal Technical Reference Manual

2. Loosen the adjusting screw with a coin, and carefully move the detecting lever up.
Adjusting
screw
Detecting
lever
3. Tighten the adjusting screw, and check to be sure that the detecting lever moves freely.
4. Replace the paper roll.

3.4.4 Adjusting the DIP Switches

The printer has two sets of DIP switches. The function of the DIP switches is different for each
interface model.

3.4.4.1 Changing the DIP Switch Settings

If you need to change settings, follow the steps below to make your changes:
CAUTION:
Turn off the power while removing the DIP switch cover to prevent an electric short,
which can damage the printer.
Use a crosshead screwdriver to remove the screw holding the DIP switch cover.
1. Make sure the printer is turned off.
Rev. A
TM-H6000II Technical Reference Guide
Setup 3-19