Front Pe (Paper End) Detector Removal; Rear Pe Detector Removal - Epson FX 890 - B/W Dot-matrix Printer Service Manual

4.2.10.6 Front PE (Paper End) Detector Removal

1. Remove the printer mechanism. (See Section 4.2.9.)
2. Release 2 clips attaching the front PE detector to the REAR PAPER GUIDE ASSEMBLY, and
remove the detector.
3. Disconnect the harness from the detector.

4.2.10.7 Rear PE Detector Removal

1. Remove the printer mechanism. (See Section 4.2.9.)
2. Hold the printer mechanism horizontally.
3. Release 2 clips securing Rear PE detector to REAR PAPER GUIDE ASSEMBLY. ( )
4. Release 2 notches on the REAR PAPER GUIDE ASSEMBLY securing the detector, and slide
the detector toward rear a little. Then remove the detector by pulling it downward. ( )
5. Disconnect the harness from the detector.
Rev. B
Figure 4-17. Front PE Detector Removal
Figure 4-18. Rear PE Detector Removal
FX-1180/FX-880 Service Manual
Chapter 4 DISASSEMBLY AND ASSEMBLY
4-19