Epson C11C560111 - PLQ 20 B/W Dot-matrix Printer User Manual page 54

Paper width measurement
You can set the timing when the printer measures the width of
the paper. When you select After loading, the printer measures
the width just after it loads the paper. When you select Before
printing, it makes the measurement just before printing the first
line.
Right paper edge detection
This setting allows you to determine whether the printer prints
excess data when the data is longer than the paper width. When
you select On, the excess data is not printed. When you select Off,
the printer prints the excess data on the next line.
Low-noise mode
When this mode is set to On, the noise is reduced, but the printing
speed is slower.
Broken pin compensation
When this feature is On, printing is done at normal quality if one
of the 24 pins is broken. You need to set the broken pin number
at the Broken pin number setting.
Broken pin number
Select the pin number of the broken pin. The broken pin number
is shown on the sheet of current default settings that can be
printed in the default settings mode. The gap on the sloping line
above the pin numbers shows the broken pin number.
Roll Paper
When you use roll paper with the optional roll paper holder, set
this option to On. This mode is activated when you select On and
the Passbook mode is set to Off.
44
Changing your Printer's Settings