Oki ML3410 Handbook page 50

Parallel I/F
Serial I/F
ML3410 ( 96-02-07 )
Time Out Print
(Epson/IBM)
Auto Select
Sensor Disable
I-Prime
Pin 18
Auto Feed XT
(Epson/IBM)
Parity None , Odd,
Even Serial Data 7 or
8 Bits
Protocol
Valid , Invalid
No ,Yes
No ,Yes
Buffer Print , Line
End, Invalid
+5V , 0V
Invalid , Valid
8 Bits ,7 Bits
Ready/Busy , X-ON/
X-OFF
When set to Valid,
con- tents of the
buffer will print when
no more data is
received for a certain
period of time.
End, Invalid Buffer
Print = I-Prime makes
printer print con- tents
of buffer; Line End =
I-Prime makes printer
print to the end of the
current line; Invalid =
I-Prime signal is
ignored.
Determines whether
volt-age is supplied to
pin 18.
Epson emulation.
Some interface
cables are wired so
that the XT signal
always causes an
auto-matic line feed.
The In-valid setting
eliminates this. Use
the Valid setting if
your system uses the
XT signal for
automatic line feed.